Start with resistor R1. It is the one with red-red-brown-gold rings. Orientation is not important.
Then R2 and R3. They are the one with yellow-violet-red-gold rings and once again, the orientation is not important.
After placing the 3 resistors, turn the board over to solder them in place.
Then, cut off the extra bits of wire sticking out of the PCB (shorten the "legs" of the resistors).
TIP: To keep the components in place when you flip the board to do the soldering, you can bend the wires in 45 degrees.
TIP: When cutting extra wires, make sure you either wear a protective goggle or that you hold the extra pice with your other hand.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.